Fisher and Paykel DD24STI7 BOOK INSTL DD24S PH7 US CA EN (English) - Page 9

Optionally Hard Wiring Prior To Installation

Get Fisher and Paykel DD24STI7 PDF manuals and user guides View all Fisher and Paykel DD24STI7 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

7 OPTIONALLY HARD WIRING PRIOR TO INSTALLATION 9 7a REMOVE THE DRAWER 43 1 Product may move. Mark chassis position on cavity Access cover 2 To prevent kinked hoses, we recommend rotating the drawer counter-clockwise and re5sting it on its side after removal. 3 4"1(01000mmmm) Press the release tabs in on either side and push back to release drawer from runners. 7c TERMINATE THE WIRING AS SHOWN Remove knock-out for cable clamp and fit a suitable cable clamp for the conduit. 7b REMOVE THE ACCESS COVER & POWER CORD 4 5 6 8 7 WARNING! Electrical Shock Hazard Before continuing, ensure that the product is disconnected from the power supply. Failure to follow this warning may result in electrical shock, injury or fire. 87 7d REFIT THE DRAWER ONTO THE RUNNERS & CLOSE Pounllbfootrhwsairddesth4e"(r1e0le0amsemt)abs Ensure the drawer is now rotated clockwise back. 175 11 11 10 9 12 Use copper conductors only. 179 186 Ensure the release tabs on 153 both sides are reset fully. Before refitting the drawer, ensure the hoses are not twisted and the latches at the rear of each drawer runner are facing forward. 164

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
9
OPTIONALLY HARD WIRING PRIOR TO INSTALLATION
9
12
11
11
10
4
5
6
7
7
8
8
7a
7c
7
7b
REMOVE THE DRAWER
TERMINATE THE WIRING AS SHOWN
REMOVE THE ACCESS COVER & POWER CORD
Remove knock-out for cable clamp and
fit a suitable cable clamp for the conduit.
Use copper conductors only.
2
100 mm
1
3
4
5
To prevent kinked hoses, we recommend
rotating the drawer counter-clockwise
and resting it on its side after removal.
Product may move.
Mark chassis position
on cavity
Access
cover
Press the release tabs in on
either side and push back
to release drawer from
runners.
3
4” (100mm)
18
19
15
16
17
Before refitting the drawer,
ensure the hoses are not
twisted and the latches at
the rear of each drawer
runner are facing forward.
Ensure the release tabs on
both sides are reset fully.
Ensure the drawer
is now rotated
clockwise back.
13
14
15
16
1²
Pull forward the release tabs
on both sides 4”(100
mm)
7d
REFIT THE DRAWER ONTO THE RUNNERS & CLOSE
Electrical Shock Hazard
Before continuing, ensure that the product is
disconnected from the power supply.
Failure to follow this warning may result in
electrical shock, injury or fire.
WARNING!