Frigidaire FGHD2465NF Complete Owner's Guide (English) - Page 17

Solutions To Common Dishwashing Problems - installation guide

Page 17 highlights

SOLUTIONS TO COMMON DISHWASHING PROBLEMS Normal Sounds You Will Hear • Normal sounds include water fill, water circulation and motor sounds. • There is a noticeable change in sound when the wash action switches between the lower and middle spray arm. This is normal since each spray arm has its own sound. • It is normal for dishwasher to pause (no sound) when the wash action is switching between the lower and middle spray arms. Etching • Using too much detergent in soft or softened water causes this film that cannot be removed. • Adjust the amount of detergent based on the water hardness. (Check Detergent Usage Guide). • Lower the water temperature. • Use Air Dry option. Water in Bottom of Tub • Water left in bottom of tub after cycle is complete is not normal. If water remains in the bottom of the tub, dishwasher may not be draining properly. (See Dishwasher Does Not Drain Properly.) Dishware Chipped • Load with care and do not overload. (See Preparing and Loading Dishes.) • Place delicate items in top rack. • Place glasses securely against pins and not over pins. • Load items so they are secure and don't jar loose when moving racks in and out. Move racks in and out slowly. • Make sure tall glasses and stemware will clear top of tub when rack is pushed in. • Fine antique china and crystal should be hand-washed. Cycle Takes a Long Time • Is cycle in a water heating delay? • Has the delay start option been selected? • Has the sanitize option been selected? Selecting this option will lengthen the cycle. Dishwasher Won't Run • Check to see if circuit breaker is tripped or if a fuse is blown. • Make sure water supply is turned on. • Check to see if cycle is set correctly. (See Operating Instructions.) • Is dishwasher set for delay start option? • Make sure door is closed and latched. Dishwasher Does Not Drain Properly • If unit is hooked up to a food waste disposer, make sure the disposer is empty. • Check to see if the knockout plug has been removed from inside the food waste disposer inlet. • Check to see if drain hose is kinked. • Make sure cycle is complete, not in a pause. Dishwasher Won't Fill • Is water supply turned on? • Does overfill protector move up and down freely? (See Overfill Protector section.) Dishwasher Has an Odor • Soiled dishes left in dishwasher too long can create an odor. Use Rinse & Hold cycle. • There will be a "new" smell when first installed. This is normal. • Check to see if unit is draining properly. (See Dishwasher Does Not Drain Properly.) 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20

17
SOLUTIONS TO COMMON DISHWASHING PROBLEMS
Normal Sounds You Will Hear
Normal sounds include water fill, water circulation
and motor sounds.
There is a noticeable change in sound when the wash
action switches between the lower and middle spray
arm. This is normal since each spray arm has its own
sound.
It is normal for dishwasher to pause (no sound) when
the wash action is switching between the lower and
middle spray arms.
Etching
Using too much detergent in soft or softened water
causes this film that cannot be removed.
Adjust the amount of detergent based on the water
hardness. (Check Detergent Usage Guide).
Lower the water temperature.
Use Air Dry option.
Water in Bottom of Tub
Water left in bottom of tub after cycle is complete is
not normal. If water remains in the bottom of the tub,
dishwasher may not be draining properly. (See
Dishwasher Does Not Drain Properly.)
Dishware Chipped
Load with care and do not overload. (See Preparing
and Loading Dishes.)
Place delicate items in top rack.
Place glasses securely against pins and not over pins.
Load items so they are secure and don’t jar loose when
moving racks in and out. Move racks in and out slowly.
Make sure tall glasses and stemware will clear top of
tub when rack is pushed in.
Fine antique china and crystal should be hand-washed.
Dishwasher Won’t Run
Check to see if circuit breaker is tripped or if a fuse is
blown.
Make sure water supply is turned on.
Check to see if cycle is set correctly.
(See Operating Instructions.)
Is dishwasher set for delay start option?
Make sure door is closed and latched.
Dishwasher Does Not Drain
Properly
If unit is hooked up to a food waste disposer, make
sure the disposer is empty.
Check to see if the knockout plug has been removed
from inside the food waste disposer inlet.
Check to see if drain hose is kinked.
Make sure cycle is complete, not in a pause.
Dishwasher Won’t Fill
Is water supply turned on?
Does overfill protector move up and down freely?
(See Overfill Protector section.)
Dishwasher Has an Odor
Soiled dishes left in dishwasher too long can create
an odor. Use Rinse & Hold cycle.
There will be a “new” smell when first installed. This
is normal.
Check to see if unit is draining properly. (See
Dishwasher Does Not Drain Properly.)
Cycle Takes a Long Time
Is cycle in a water heating delay?
Has the delay start option been selected?
Has the sanitize option been selected?
Selecting this
option will lengthen the cycle.