Frigidaire FGHG2368TF Complete Owner s Guide - Page 10

INSTALLING DOOR HANDLES CAUTION Wear gloves and safety goggles. Use extreme CAUTION when installing these handles. Door Handle Mounting Instructions for Frigidaire & Frigidaire Gallery Mounting Refrigerator Handles 1 Remove handles from carton and any other protective packaging. 2 Position fresh food handle end caps over upper and lower pre-installed shoulder bolts (A) that are fastened into door, ensuring the holes for the set screws are facing towards the opposite door. 3 While holding handle firmly against door, fasten upper and lower Allen set screws (B) with supplied Allen wrench. 4 Repeat steps 2 and 3 to install opposite handle. Ensure the holes for the set screws are facing towards the first door. Mounting Freezer Handle 5 Position freezer handle end caps over left and right preinstalled shoulder bolts (A) that are fastened to the door, ensuring the holes for the set screws are facing down. 6 While holding handle firmly against door, loosely tighten right Allen set screw (B) with supplied Allen wrench until there is no gap between handle and door. 7 Still holding the handle firmly to the door, firmly tighten left Allen set screw (B) with supplied Allen wrench. 8 Return to the right Allen set screw (B) and firmly tighten with supplied Allen wrench.  NOTE When tightening the Allen set screws, it is imperative that force be applied to the longer arm of the Allen wrench supplied in the handle packaging.  NOTE All set screws should be tightened so the screw is below the surface of the handle. The handles should be drawn tight to freezer and refrigerator doors with no gaps. Opening the opposite door while tightening the Allen screw makes installation easier. The door handle may loosen over time or if it was installed improperly. If this happens, tighten the set screws on the handles. 10