Frigidaire FGHG2368TF Complete Owner s Guide - Page 38

Concern, Potential Cause, Common Solution, Opening/Closing Of Doors/Drawers, Running of Refrigerator

Page 38 highlights

BEFORE YOU CALL Concern Potential Cause Common Solution Opening/Closing Of Doors/Drawers Door(s) will not close. • Door was closed too hard, causing other door to open slightly. • Close both doors gently. • Refrigerator is not level. It rocks on the floor when moved slightly. • Ensure floor is level and solid, and can adequately support the refrigerator. Contact a carpenter to correct a sagging or sloping floor. • Refrigerator is touching a wall or cabinet. • Ensure floor is level and solid, and can adequately support the refrigerator. Contact a carpenter to correct a sagging or sloping floor. Drawers are difficult to move. • Food is touching shelf on top of drawer. • Track that drawers slide on is dirty. • Remove top layer of items in drawer. • Ensure drawer is properly installed on track. Running of Refrigerator Compressor does not run. • Freezer control is set to "OF". • Refrigerator is in defrost cycle. • Clean drawer, rollers, and track. See Care & Cleaning. • Set freezer control. • This is normal for a fully automatic defrost refrigerator. The defrost cycle occurs periodically, lasting about 30 minutes. • Plug at electrical outlet is disconnected. • Ensure plug is tightly pushed into outlet. • House fuse blown or tripped • Check/replace fuse with a 15 amp time- circuit breaker. delay fuse. Reset circuit breaker. • Power outage. • Check house lights. Call local electric company. Refrigerator seems to run too much or too long. • Your variable speed compressor is designed to run 100% of the time except during the defrost cycle. At times it will run faster, such as after a defrost cycle. • It is normal for the compressor to run continuously except during defrost mode. Digital Temperature Setting Display Digital temperature displays an error. • Electronic control system has detected a performance problem. • Call your Electrolux service representative, who can interpret any messages or number codes flashing on the digital displays. 38

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40

38
BEFORE YOU CALL
Concern
Potential Cause
Common Solution
Opening/Closing Of Doors/Drawers
Door(s) will
not close.
• Door was closed too hard,
causing other door to open
slightly.
• Refrigerator is not level.
It rocks on the floor when
moved slightly.
• Refrigerator is touching a
wall or cabinet.
• Close both doors gently.
Ensure floor is level and solid, and can
adequately support the refrigerator.
Contact a carpenter to correct a sagging
or sloping floor.
Ensure floor is level and solid, and can
adequately support the refrigerator.
Contact a carpenter to correct a sagging
or sloping floor.
Drawers are
difficult to
move.
• Food is touching shelf on top
of drawer.
• Track that drawers slide on
is dirty.
• Remove top layer of items in drawer.
• Ensure drawer is properly installed on
track.
• Clean drawer, rollers, and track. See Care
& Cleaning.
Running of Refrigerator
Compressor
does not run.
• Freezer control is set to “OF”.
• Refrigerator is in defrost
cycle.
• Plug at electrical outlet is
disconnected.
• House fuse blown or tripped
circuit breaker.
• Power outage.
• Set freezer control.
• This is normal for a fully automatic defrost
refrigerator. The defrost cycle occurs
periodically, lasting about 30 minutes.
• Ensure plug is tightly pushed into outlet.
• Check/replace fuse with a 15 amp time-
delay fuse. Reset circuit breaker.
• Check house lights. Call local electric
company.
Refrigerator
seems to run
too much or
too long.
• Your variable speed
compressor is designed to
run 100% of the time except
during the defrost cycle. At
times it will run faster, such
as after a defrost cycle.
• It is normal for the compressor to run
continuously except during defrost mode.
Digital Temperature Setting Display
Digital
temperature
displays an
error.
• Electronic control system
has detected a performance
problem.
• Call your Electrolux service representative,
who can interpret any messages or
number codes flashing on the digital
displays.