Fujitsu MJA2500BH Maintenance Manual - Page 105
RECALIBRATE X, Error reporting conditions, Error information
View all Fujitsu MJA2500BH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
5.3 Host Commands (1) RECALIBRATE (X '10' to X '1F') This command performs the calibration. When the device completes the calibration, the device reports the status to the host system. This command can be issued in the LBA mode. • Error reporting conditions (1) An error was detected during head positioning (ST = 51h, ER = 02h). (2) A SATA communication error occurred (ST = 51h, ER = 14h). At command issuance (Shadow Block Registers setting contents) CM 0001xxx x DH x x x x xx CH xx CL xx SN xx SC xx FR xx At command completion (Shadow Block Registers contents to be read) ST Status information DH x x x x xx CH xx CL xx SN xx SC xx ER Error information Note: Also executable in LBA mode C141-E293 5-31
5.3
Host Commands
C141-E293
5-31
(1)
RECALIBRATE (X
'
10
'
to X
'
1F')
This command performs the calibration.
When the device completes the
calibration, the device reports the status to the host system.
This command can be issued in the LBA mode.
•
Error reporting conditions
(1) An error was detected during head positioning (ST = 51h, ER = 02h).
(2) A SATA communication error occurred (ST = 51h, ER = 14h).
At command issuance (Shadow Block Registers setting contents)
CM
0
0
0
1
x
x
x
x
DH
x
x
x
x
xx
CH
CL
SN
SC
FR
xx
xx
xx
xx
xx
At command completion (Shadow Block Registers contents to be read)
ST
Status information
DH
x
x
x
x
xx
CH
CL
SN
SC
ER
xx
xx
xx
xx
Error information
Note:
Also executable in LBA mode