Garmin Edge 800 Edge 800 Quick Start Guide - Page 8

1. Connect the heart rate monitor module ➊ to the strap. ➊ 2. Wet both electrodes ➋ on the back of the strap to create a strong connection between your chest and the transmitter. ➋ 3. Wrap the strap around your chest, and connect it. The Garmin logo should be rightside up. 4. Bring the device within range (3 m) of the heart rate monitor. TIP: If the heart rate data is erratic or does not appear, you may have to tighten the strap on your chest or warm up for 5-10 minutes. After you put on the heart rate monitor, it is on standby and ready to send data. When the heart rate monitor is paired, a message appears, and appears solid on the status page. Installing the GSC 10 note: If you do not have a GSC 10, you can skip this task. Both magnets must be aligned with their respective indication lines for the Edge to receive data. 1. Place the GSC 10 on the rear chain stay (on the side opposite the drive train). NOTE: Place the flat rubber pad ➊ or the triangle-shaped rubber pad between the GSC 10 and the chain stay for stability. 6 Edge 800 Quick Start Manual