Garmin G2000 Pilots Guide - Page 454

SYSTEM OVERVIEW FLIGHT INSTRUMENTS EIS Automatic Flight Control System The following AFCS controls are located in the cockpit separately from the PFD and MFD: AP DISC Switch Disengages the autopilot and interrupts pitch trim operation (Autopilot Disconnect) The AP DISC Switch is located on the control stick. This switch may be used to acknowledge an autopilot disconnect alert and mute the associated aural tone. CWS Button While pressed, allows manual control of the aircraft while the autopilot is (Control Wheel Steering) engaged and synchronizes the flight director's Command Bars with the current aircraft pitch (if not in Glideslope Mode) and roll (if in Roll Hold Mode) Upon release of the CWS Button, the flight director may establish new reference points, depending on the current pitch and roll modes. CWS operation details are discussed in the flight director modes section. The CWS Button is located on the control stick. GA Switch (Go Around) Selects flight director Go Around Mode If an approach procedure is loaded, this switch also activates the missed approach when the selected navigation source is FMS or when the navigation source is VOR/LOC and a valid frequency has been tuned. The GA Switch is located on the throttle. MET Switch Used to command manual electric pitch trim (Manual Electric Trim) An MET Switch is located on the pilot and copilot control stick. Press DN (forward) and UP (rearward) for manual electric trim. & CNS AUDIO PANEL AVOIDANCE MANAGEMENT FLIGHT HAZARD AFCS ADDITIONAL FEATURES APPENDICES INDEX 440 Garmin G2000 Pilot's Guide for the Cessna T240 190-01263-01 Rev. A