Gateway 610 Gateway 610 Media Center PC User's Guide - Page 98

The Ringer Equivalence Number REN is used

Page 98 highlights

Telecommunications per Part 68 of the Code of Federal Regulations (CFR47) (applicable to products fitted with USA modems) Your modem complies with Part 68 of the Code of Federal Regulations (CFR47) rules. On the computer or modem card is a label that contains the FCC registration number and Ringer Equivalence Number (REN) for this device. If requested, this information must be provided to the telephone company. A telephone line cord with a modular plug is required for use with this device. The modem is designed to be connected to the telephone network or premises wiring using a compatible modular jack which is Part 68 compliant. See installation instructions for details. The Ringer Equivalence Number (REN) is used to determine the number of devices which may be connected to the telephone line. Excessive RENs on a telephone line may result in the devices not ringing in response to an incoming call. In most areas, the sum of RENs should not exceed five (5.0). To be certain of the number of devices that may be connected to a line, as determined by the total RENs, contact the local telephone company. If this device causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. The telephone company may request that you disconnect the equipment until the problem is resolved. order for you to make necessary modifications to maintain uninterrupted service. This equipment cannot be used on telephone companyprovided coin service. Connection to party line service is subject to state tariffs. Contact the state public utility commission or public service commission for information. When programming or making test calls to emergency numbers: • Remain on the line and briefly explain to the dispatcher the reason for the call. • Perform such activities in the off-peak hours such as early morning or late evenings. The United States Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a computer or other electronic device to send any message via a telephone fax machine unless such message clearly contains, in a margin at the top or bottom of each transmitted page or on the first page of the transmission, the date and time it is sent, an identification of the business, other entity, or other individual sending the message, and the telephone number of the sending machine or such business, other entity, or individual. Refer to your fax communication software documentation for details on how to comply with the fax-branding requirement. The telephone company may make changes in its facilities, equipment, operations, or procedures that could affect the operation of this equipment. If this happens, 92 the telephone company will provide advance notice in

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108

92
Telecommunications per Part 68 of the Code of
Federal Regulations (CFR47) (applicable to products
fitted with USA modems)
Your modem complies with Part 68 of the Code of Federal
Regulations (CFR47) rules. On the computer or modem
card is a label that contains the FCC registration number
and Ringer Equivalence Number (REN) for this device.
If requested, this information must be provided to the
telephone company.
A telephone line cord with a modular plug is required
for use with this device. The modem is designed to
be connected to the telephone network or premises
wiring using a compatible modular jack which is Part 68
compliant. See installation instructions for details.
The Ringer Equivalence Number (REN) is used
to determine the number of devices which may be
connected to the telephone line. Excessive RENs on a
telephone line may result in the devices not ringing in
response to an incoming call. In most areas, the sum of
RENs should not exceed five (5.0). To be certain of the
number of devices that may be connected to a line, as
determined by the total RENs, contact the local telephone
company.
If this device causes harm to the telephone network,
the telephone company will notify you in advance that
temporary discontinuance of service may be required. The
telephone company may request that you disconnect the
equipment until the problem is resolved.
The telephone company may make changes in its
facilities, equipment, operations, or procedures that could
affect the operation of this equipment. If this happens,
the telephone company will provide advance notice in
order for you to make necessary modifications to maintain
uninterrupted service.
This equipment cannot be used on telephone company-
provided coin service. Connection to party line service
is subject to state tariffs. Contact the state public utility
commission or public service commission for information.
When programming or making test calls to emergency
numbers:
• Remain on the line and briefly explain to the
dispatcher the reason for the call.
• Perform such activities in the off-peak hours such as
early morning or late evenings.
The United States Telephone Consumer Protection
Act of 1991 makes it unlawful for any person to use a
computer or other electronic device to send any message
via a telephone fax machine unless such message
clearly contains, in a margin at the top or bottom of each
transmitted page or on the first page of the transmission,
the date and time it is sent, an identification of the
business, other entity, or other individual sending the
message, and the telephone number of the sending
machine or such business, other entity, or individual.
Refer to your fax communication software documentation
for details on how to comply with the fax-branding
requirement.