Gateway 960 Installing Your Gateway 960 or 980 Server into a Rackmount Cabinet - Page 16
Rotating and installing the front cover drive, faceplate, Installing the rackmount handles
View all Gateway 960 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Installing Your Gateway Server into a Rackmount Cabinet Rotating and installing the front cover drive faceplate To rotate and install the front cover drive faceplate: 1 Press the faceplate release tabs inward to remove the drive bay faceplates from the front cover, then pull the faceplates away from the front cover. 2 Rotate the faceplates 90 degrees, then snap them into the front cover slots that correspond to the drive bays you will not use. Installing the rackmount handles Tools you need to complete this task: Phillips screwdriver Rackmount kit parts you need to complete this task: 2 rackmount handles 8 hex screws #6-32 × 0.25" 12 www.gateway.com
12
Installing Your Gateway Server into a Rackmount Cabinet
www.gateway.com
Rotating and installing the front cover drive
faceplate
To rotate and install the front cover drive faceplate:
1
Press the faceplate release tabs inward to remove the drive bay faceplates
from the front cover, then pull the faceplates away from the front cover.
2
Rotate the faceplates 90 degrees, then snap them into the front cover slots
that correspond to the drive bays you will not use.
Installing the rackmount handles
Tools you need to complete this task:
Rackmount kit parts you need to complete this task:
Phillips screwdriver
8 hex screws
#6-32 × 0.25
"
2 rackmount
handles