GE AJCS12DCB Owners Manual - Page 18

Installation instructions WINDOW INSTALLATION--OPTIONAL (cont.) [] PREPAREWINDOW [] Mark the centerline of the stool, Measure from the centerline 13%" on both sides for the panel cuts. [] Measure 12%" from the centerline on both sides for the sill support brackets. Centerline Centerline _-_ 13%" -_ 1 Sill [] INSTALL SILL SUPPORTS [] Assemble the sill supports. Do not fully tighten the spacer mounting screws at this time. Type B Type E support Spacer mounting screws Type (A) [] Turn the bolts and tighten the lock nuts to make the sill supports level or tilt down 1/8" to the outside. Line up the "V" notch with 12%" marks. Drill pilot holes and attach the sill supports. Average sill /_ Sill support Narrow sill Spacer Adjusting bolt -_ Large washer_ (For use with wood sills) Offset sill (such as brick or stone) [] Before attaching the sill supports, place them on the window stool. Select the spacer position that will place the spacer near the outermost point on the sill. Tighten the spacer mounting screws. Screws are in position Sill support "V" notch NOTES: • On narrow sills, there may not be enough room to use the lock nut. • A deep offset sill may require a longer adjusting bolt than the standard hex head bolt provided. • On wood sills use the large washer between the bolt head and the sill. This prevents the bolt from digging into the wood. 18