GE AJCS12DCB Owners Manual - Page 19
Measure, Cut And, Install, Filler Panels
View all GE AJCS12DCB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Installation instructions [] MEASURE, CUT AND INSTALL FILLER PANELS [] Measure from the edge of the panel marks (see Prepare the Window) to the inside of the window track on each side. (A and B) Sill / Wind°w track_,_k Gasket-_ Angle Gasket ___anel _j¢/_ Angle Type C (painted screws) 4, _/-_' ' A '_'_ Left side 13%" i 133X" Width ofthe air "_'_ conditioner (panel marks) ":"" ___ B_ Right side [] Mark the A and B measurements on each side of the filler panel board. Cut the panels and discard the center piece. Note position of the notches. •B A= Right Left side side --_ Filler Panels _• = Cut o panels o ,_ and = discard -_ --_ center _.. o _, piece , _ • a u v [] Put together the panel assemblies. Remove the paper backing from the case side gasket and attach it to the angle. Push a pencil point through the gaskets to locate the holes in the angles. Tab._/4 [] Install the panels in the window. Place the spring clips 3" from the top and the bottom. Squeeze and push the clips to fit in the window track and the tab into the sill support. l Hook the tab into the sill support 19