GE CVM9179ELDS Use and Care Manual - Page 24

USING THE OVEN: Other Features Other Features Filter Replace Reminder When the Filter Replace light turned on, replace filter and press Reset Filter and hold for 3 seconds to reset. A filter is only needed for models that are not vented to the outside. Vent Fan The vent fan removes steam and other vapors from surface cooking. Press Vent Fan once for high fan speed, twice for medium fan speed, three times for low fan speed or a fourth time to turn the fan off. Surface Light Press Surface Light once for bright light, twice for the night light or a third time to turn the light off. Automatic Fan An automatic fan feature protects the microwave from too much heat rising from the cooktop below it. It automatically turns on if it senses too much heat. If you have turned the fan on you may find that you cannot turn it off. The fan will automatically turn off when the internal parts are cool. It may stay on for 30 minutes or more after the cooktop and microwave controls are turned off. Chef Connect Use the Chef Connect feature for connecting your microwave to a GE Appliances range to sync your vent fan, cooktop surface lights and clock via Bluetooth technology. 1 You must have a Chef Connect enabled range. To pair your microwave for the first time, initiate the Chef Connect process on the GE Appliances range. Refer to the range owner's manual for instructions 2 On the microwave, hold Chef Connect button for 3 seconds. The Bluetooth icon on the display will start flashing as the microwave starts to search and pair with your GE Appliances range. The icon will remain ON after pairing successfully. If a GE Appliances range is not found within 2 minutes during search mode the microwave will stop searching and the Bluetooth icon will turn OFF. On initial setup, the setup protocol will start. If the Chef Connect feature is enabled the default settings are as follows: - Display clock sync: ON - Auto surface light: ON (HIGH setting) - Auto vent fan: OFF - Auto off: 15 minutes 3 Turn the dial to select Surface Light Sync On/Off. Press the dial to confirm. If on, it allows the microwave surface lights to turn on at HIGH level automatically when the paired range's cooktop burner turns ON. If OFF, the microwave surface lights will not automatically turn on when a cooktop burner turns on. 24 4 Turn the dial to select Vent Fan Sync ON/OFF. Press the dial to confirm. If ON, it allows the microwave vent fan to turn on at LOW speed automatically when the paired range's cooktop burner turns on. If OFF, the vent fan will not turn ON automatically when a cooktop burner is turned on. Pairing is now complete, the Chef Connect feature is now on. NOTE: If there is no sync option selected during set up, 5 minutes after icon turns ON, the units will return to stand-by mode and use the default settings. After completing the setting per above steps, your microwaves vent fan and surface light could be set to turn on automatically when the cooktop burner is turned on. The cooktop and range clock display will be synced to display the same time. The vent fan and cooktop light will be set to automatically turn off 15 minutes after the cooktop burner is turned OFF. If desired, the light, fan, and auto off settings can now be changed using option in Settings. Press Chef Connect once to temporarily turn OFF communication between the microwave and range. Press again to turn communication back ON. The icon will illuminate when ON. In the case of an unintended disconnect such as lost power to the microwave or range the connection will remain after power resumed. For very short power interruptions, the power may need to be reset in order to reconnect NOTE: To unpair the microwave from the range, press and hold the Chef Connect button on the microwave for 3 seconds. The Bluetooth icon will start to flash. Press cancel or wait 2 minutes for the flashing to stop. You may need to unpair when the GE Appliances range is replaced or serviced. 49-40778