GE GFSF2KEXCC Use and Care Manual - Page 14

Installation Instructions Refrigerator Models 20 and 22 Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.com In Canada, call 1.800.561.3344 or Visit our Website at: www.geappliances.ca BEFORE YOU BEGIN Read these instructions completely and carefully. • IMPORTANT - Save these instructions for local inspector's use. • IMPORTANT - Observe all governing codes and ordinances. • Note to Installer - Be sure to leave these instructions with the Consumer. • Note to Consumer - Keep these instructions for future reference. • Skill level - Installation of this appliance requires basic mechanical skills. • Completion time - Refrigerator Installation 20 minutes Water Line Installation 30 minutes • Proper installation is the responsibility of the installer. • Product failure due to improper installation is not covered under the Warranty. TOOLS YOU MAY NEED Adjustable Wrench 3/8″ and 5/16″ Socket Ratchet/Driver 1/4″ Outer Diameter Compression Nut and Ferrule (sleeve) (icemaker models only) Phillips Head Screwdriver 3/32″, 1/8″ and 3/16″ Allen wrenches 1/8″ Drill Bit and Electric or Hand Drill Tape measure PREPARATION MOVING THE REFRIGERATOR INDOORS If the refrigerator will not fit through a doorway, the refrigerator door and freezer drawer can be removed. • To remove the refrigerator door, see Step 1 in the Reversing the Door Swing section. • To remove the freezer drawer, see the Removing the Freezer Drawer section. WATER SUPPLY TO THE ICEMAKER AND DISPENSER (ON SOME MODELS) If the refrigerator has an icemaker, it will have to be connected to a cold water line. A GE water supply kit (containing tubing, shutoff valve, fittings and instructions) is available at extra cost from your dealer, by visiting our Website at ge.com (in Canada at www.geappliances.ca) or from Parts and Accessories, 800.626.2002 (In Canada 1.888.661.1616). 14 Pencil Wire Cutters 1/4″ Nut Driver Level