GE JX827BN Installation Instructions - Page 1
GE JX827BN - Trim Kit For 1.0 cu. Ft. Microwave Ovens Manual
View all GE JX827BN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Microwave Oven Installation instructions for your new Built-In Trim Kit JX827BN, JX827WN, JX827SS, JX827CD CAUTION: • Before you begin-Read these instructions, Owner's Manual and Important Safety Instructions completely and carefully. • This Kit is for use on models: JEM21K/L, JEM23K/L, JEM25L/GN/GV/GY/WN/WV/WY/BF/WF, JES833WY, JEM825K, JEM27KWH/LWH, JEM31L/M/GN/GV/GY/WV/WY/GA/WA/CA/BF/CF/WF/SF, JEM33L/M, JEM34M and ZEM200WN/WV/WY/GV/GY/SY/GW/WA/SA/GA/SF/BF/WF. • This kit can be installed alone or over any General Electric/Hotpoint/RCA single electric wall oven. • Do not alter or modify any part of this kit or the oven. • Observe all governing codes and ordinances. • Oven must be plugged into a properly grounded 3-hole, 120 volt receptacle as required by the National Electrical Code. • Unplug the microwave oven before attempting installation of this kit. • Save these instructions (for Local Inspectors and Future Reference). Parts List 1. Base Pan 2. Rear Duct 3. Side Covers (2) 4. Top Trim 5. Bottom Trim 1 6. Side Trims 7. Rear Holddown Brackets Screws A (9 required 1 extra) B (4 required 1 extra) C (10 required 2 extra) D (4 required 1 extra) E (4 required 1 extra) 4 5 6 2 Parts Inventory 7 A B D E C 3 3 Screw A Screw B Screw C Screw D Screw E Note: This kit has extra screws to prevent technician from spending extra time locating a replacement in case they lose one during installation. Cabinet Cutout Dimensions and Specifications Allow 1-1⁄4" for overlap of the Microwave Oven Kit Trim over all the edges of the cutout for the Microwave Oven Kit. WIDTH 24-7⁄ 8"±1 ⁄ 16" DEPTH HEIGHT 15"±1 ⁄ 16" 16-1/4" STTRRIIMPS 16" Min. receptacle outside cutout 18" Min. receptacle inside cutout 26-1/8" 120 volt-60 Hertz grounded power receptacle. For Installation Above a Built-In Oven Microwave oven should be installed on a 3⁄8" plywood base and supported by 2x4 or 1x2 equivalent runners on all sides. Base must be capable of supporting a minimum of 100 lbs. 24-7⁄ 8"± 1⁄16" 15"± 1⁄16" 18" Min. receptacle in cabinet 16" Min. receptacle outside cabinet