Gigabyte GA-F2A88X-UP4 User Manual - Page 64
Installing the SATA RAID/AHCI Driver and Operating System, A. Installing Windows 8/7
View all Gigabyte GA-F2A88X-UP4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
3-2 Installing the SATA RAID/AHCI Driver and Operating System With the correct BIOS settings, you are ready to install the operating system. A. Installing Windows 8/7 (The following instructions use Windows 8 as the example operating system.) Step 1: You need to install the SATA RAID/AHCI driver during the OS installation. Use an alternative system to copy the SATA RAID/AHCI driver from the motherboard driver disk to a USB flash drive. Copy the Hw8_A88 folder under BootDrv in the driver disk. Step 2: Boot from the Windows 8 setup disk and perform standard OS installation steps. When the screen requesting you to load the driver appears, select Browse. Step 3: Then browse to the USB flash drive and select the location of the driver. The locations of the drivers are as follows: RAID driver for Windows 8 32-bit: Hw8_A88\RAID\x86 RAID driver for Windows 8 64-bit: Hw8_A88\RAID\x64 AHCI driver for Windows 8 32-bit: Hw8_A88\AHCI\W8 AHCI driver for Windows 8 64-bit: Hw8_A88\AHCI\W864A For Windows 7, browse to the Hw7_A88 folder. Step 4: When a screen as shown in Figure 1 appears, select AMD-RAID Controller and click Next to load the driver and continue the OS installation. Figure 1 Configuring SATA Hard Drive(s) - 64 -