Gigabyte GA-G41MT-S2PT Manual - Page 22

CMOS Setup Utility-Copyright (C) 1984-2011 Award Software MB Intelligent Tweaker(M.I.T.) } Advanced Timing Control [Press Enter] ******** Mother Board Voltage Control ******** Voltage Types Normal Current >>> CPU CPU Vcore 1.30000V [Auto] CPU Termination 1.200V [Auto] >>> DRAM DRAM Voltage 1.500V [Auto] Item Help Menu Level  Move Enter: Select F5: Previous Values +/-/PU/PD: Value F10: Save F6: Fail-Safe Defaults ESC: Exit F1: General Help F7: Optimized Defaults Whether the system will work stably with the overclock/overvoltage settings you made is dependent on your overall system configurations. Incorrectly doing overclock/overvoltage may result in damage to CPU, chipset, or memory and reduce the useful life of these components. This page is for advanced users only and we recommend you not to alter the default settings to prevent system instability or other unexpected results. (Inadequately altering the settings may result in system's failure to boot. If this occurs, clear the CMOS values and reset the board to default values.) Robust Graphics Booster Robust Graphics Booster (R.G.B.) helps to enhance the performance of the graphics chip and memory. Auto allows the BIOS to automatically set the R.G.B. mode based on system configurations. Options are: Auto (default), Fast, Turbo. CPU Clock Ratio (Note) Allows you to alter the clock ratio for the installed CPU. The item is present only when a CPU with unlocked clock ratio is installed. Fine CPU Clock Ratio (Note) Allows you to increase clock ratio by 0.5 for the installed CPU. The item is present only when a CPU with unlocked clock ratio is installed. CPU Frequency Displays the current operating CPU frequency. ******** Clock Chip Control DRAM Performance Control ******** Performance Enhance Allows the system to operate at three different performance levels. Standard Lets the system operate at its basic performance level. (Default) Turbo Lets the system operate at its good performance level. Extreme Lets the system operate at its best performance level. (G)MCH Frequency Latch Allows you to fix the chipset frequency at system bootup. Options for adjusting memory multiplier below may differ according to the fixed frequency. Options are: Auto (default), 200MHz, 266MHz, 333MHz. System Memory Multiplier (SPD) Allows you to set the system memory multiplier. Options are dependent on CPU FSB and the (G)MCH Frequency Latch settings. Auto sets memory multiplier according to memory SPD data. (Default: Auto) (Note) This item is present only when you install a CPU that supports this feature. - 22 -