Gigabyte GA-Z68XP-UD5 Manual - Page 94
C. Configuring a RAID array, Create a RAID Array, HBA 0: Marvell 0, Free Physical Disks
UPC - 818313013033
View all Gigabyte GA-Z68XP-UD5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
C. Configuring a RAID array Create a RAID Array: Move the selection bar to HBA 0: Marvell 0 and press . Marvell BIOS Setup (c) 2009 Marvell Technology Group Ltd. Topology HBA 0 : Marvell 0 Virtual Disks Free Physical Disks HDD 0: WDC WD800JD-22L HDD 1: WDC WD800JD-22L Information Vendor ID : Device ID : Revision ID : BIOS Version : Firmware Version : PCIe Speed rate : Configure SATA as : Supported Mode : 1B4B 91A3 B1 1.0.0.1029 2.2.0.1113 5.0Gbps IDE Mode RAID 0 RAID 1 Help Marvell RAID on chip controller. ENTER: Operation F10: Exit/Save ESC: Return Figure 2 Under Free Physical Disks, use the key to select the hard drives to be included in the RAID array. The selected hard drive will be marked with an asterisk (*). After selecting the hard drives, press to proceed (Figure 3). Marvell BIOS Setup (c) 2009 Marvell Technology Group Ltd. Topology HBA 0 : Marvell 0 Virtual Disks Free Physical Disks * HDD 0: WDC WD800JD-22L * HDD 1: WDC WD800JD-22L Information Port ID : 0 PD ID : 0 Type ID : SATA PD Status : Unconfigured Size : 114472MB Feature Support : 1.5G 48Bit Current Speed : 1.5G Mode Model : WDC WD800JD-22LS Serial : WD-WMAM9W736333 FW version : 3.18 Help Use space bar to select the free disks to be used in the array. ENTER: Operation SPACE: Select F10: Exit/Save ESC: Return Figure 3 Appendix - 94 -