Haier DW9-TFE3ME User Manual - Page 10

How to fill rinse aid en Rinse aid This product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on the inside panel of the door . When the low rinse aid indicator "H" lights, you must load rinse aid . Loading the rinse aid Regardless of the type of detergent dispenser installed on your appliance, you must proceed as indicated below when loading the rinse aid. To open the dispenser, turn the "2" cap in an anti-clockwise direction and then pour in the rinse aid, making sure not to overfill. The amount of rinse aid used for each cycle can be regulated by turning the " 3" dose adjustor, located beneath the "2" cap, with a screwdriver. There are 6 different settings; the normal dosage setting is 3. H 23 Important Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spotting occurs, the dosage adjustor should be turned to a higher setting. If the dishes have white streaks, turn the dosage adjustor to a lower setting. How to fill the detergent dispenser Detergent 5 Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Programme overview". The 4 detergent dispenser is located on the inside panel of the door. Loading the detergent To open the " 4 " cover on the dispenser, press the "5" button. 7 The detergent for the wash cycle should be poured into the " 6 " compartment. The detergent for the pre-wash cycle should be poured into the " 7 " compartment. After the detergent has been placed in the dispenser, close the 6 cover and press down until it clicks in place. Notice: To facilitate closing the cover, remove any excess detergent on the edges of the dispenser. 9