Haier HSU-12RD03 User Manual - Page 11

Parts and Functions 17 16 15 18 A B 14 19 20 15 16 10 14 21 13 20 9. ON/OFF button 12 Used for unit start and stop. 11 21 10. TIMER ON display 10 22 11. FAN SPEED display 9 23 LOW MED HI AUTO 8 24 12. LOCK display 7 25 13. SWING UP/DOWN display 6 26 14. SLEEP display 5 27 15. HEALTH display 4 28 16. Operation mode display 29 3 30 Operation mode AUTO COOL DRY FAN HEAT 31 Remote controller 2 32 Display board 1 17.Singal sending display 18. POWER/SOFT display 19. Left/right air flow display 20. TEMP display 1.RESET When the remote controller appears abnormal, use a sharp pointed article to press this button to reset the remote controller normal. 2.LIGHT button Control the lightening and extinguishing of the indoor LED display board. 3. TIMER button Used to select TIMER ON, TIMER OFF, TIMER ON-OFF. 4. CLOCK button Used to set correct time. 5. SLEEP button Used to select sleep mode. 6. MODE button Remote controller: to display the TEMP setting. 21. TIMER OFF display 22. CLOCK display 23. TEMP button Used to select your desired temperature. 24. FAN button Used to select fan speed: LOW,MED, HI, AUTO. 25. HEALTH AIRFLOW button Used to set the health airflow mode. 26. SWING UP/DOWN button Used to select up or down air sending direction. 27. SWING LEFT/RIGHT button Used to select left/right air flow. 28. FRESH button(optional) Use to set fresh air function. 29. SET button Used to confirm timer and clock settings. AUTO COOL DRY FAN HEAT 30. POWER/SOFT button 7. TIMP button Used to set power/soft function. Used for adjusting humidity or clock time and timed time. 8. HEALTH button 31. LOCK Used to lock buttons and LED display. If pressed, the other buttons will be disabled and the lock condition Used to set healthy operation. display appears. Press it once again, lock will be The unit will generate negative ions if this function canceled and lock condition display disappears. switched on. 32. 10ć About temperature/humidity display key: Low-Temperature Heating Operation Down to 10ć 1.under the constant temperature dehumidification mode, for the first time to enter, then the remote controller displays the set temperature, the display panel displays the actual temperature, press this key, the temperature /humidity won't alternate. After adjusting the set temperature, press this key again, the remote controller will display the set temperature or the set humidity, and the display will display the actual temperature or the actual humidity at the same time. 2.Under the other modes, press this key, the display panel will display the actual humidity at present for a certain time, then the actual humidity will automatically switch back to display temperature. The display of the remote controller won't change. NOTE:(1) The following functions and related displays are not available: 28 (2) The unit is without Self-clean function. 6