Hayward TriStar VS 950 2.70 THP VS Pump Family - Owners Manual - Page 17

3. Preset Speed Setup Menu (see page 19 to program the 4 preset speeds) a. Speed "X" Name (where "X" equals 1 through 4) b. Speed "X" Speed (where "X" equals 1 through 4) 4. Diagnostics Menu (see page 20 to view product diagnostic information) a. Display Firmware Revision b. Drive Serial Number c. Motor Drive Firmware Revisions d. SVRS Revision (if applicable) e. Event Log (if applicable) Initial startup After plumbing and wiring are complete, the variable speed drive must be configured prior to use. When power is applied to the drive for the first time, the following informational screens are displayed. Screen 1. Hayward Variable Speed Pump 2. Thursday 1725rpm 1:27p 380 Watts 3. Timer 1 timer will end at 11:45p NOTE: Speeds can be selected at this time to temporarily run the pump, however, it is recommended that the drive configuration and timers be set according to individual installation site requirements (see page 18 for more details). At this point, pressing the MENU button will select the Configuration Menu. Configuration Menu Screen 1. Configuration Menu Locked Buttons Used < > Comments Press and hold < and > buttons for several seconds to unlock the Configuration Menu. 2. Configuration Menu press > to enter < > Use the > button to enter the Configuration Menu. 3. press +/- to change or > view next item 4. Time: Th 1:27PM + change or > skip + - Use + button to change clock setting. < > Use > if clock is correct. 5. Set Day and Time Thursday 1:27p + - Adjust day/time setting. < > Move to next selection, then move to next menu item. 16 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS