Hayward TriStar VS 950 2.70 THP VS Pump Family - Owners Manual - Page 22

Screen 2. No bathers in water during Quick Clean 3. Bathers in water? + yes or - no NOTE: For SVRS pump models, the SVRS feature is disabled during Quick Clean mode. When Quick Clean is pressed, the above message is displayed to alert the user that SVRS is disabled, and that all bathers should exit the pool during Quick Clean. If bathers are in the water, pressing + will return the pump to normal operation. If bathers are not in the water, pressing - will allow the pump to run in Quick Clean mode, where it will run at the Max allowed speed set in the Configuration Menu for 60 minutes. When Quick Clean is selected for non-SVRS pump models, the pump will immediately proceed to Quick Clean mode. Screen 4. SVRS Inactive Quick Clean running 5. SVRS Inactive 3450 rpm for 60 min; 6. SVRS Inactive press Resume to end NOTE: The above message will be displayed while Quick Clean is running. Quick Clean mode expires after 60 min, and it may be cancelled early by pressing the Stop/Resume button, at which time the pump would return to normal operation. Quick Clean can be extended up to 360 minutes with additional presses of the Quick clean button. For non-SVRS pump models, the SVRS Inactive message will not be shown, and the Check System LED will not flash. Remote Stop Screen 1. Remote Stop is engaged NOTE: The above message will be displayed when an installed remote stop switch is activated. The pump will remain stopped until the remote stop switch is deactivated. See page 13 for more detail. Maintenance • Clean strainer basket regularly. Do NOT strike basket. Inspect cover gasket regularly and replace as necessary. • Hayward pumps have self-lubricating motor bearings and shaft seals. No lubrication is necessary. • Keep motor clean. Keep motor air vents free of obstructions to avoid damage. Do NOT use water to hose off motor. • Occasionally, shaft seals must be replaced, due to wear or damage. Replace with genuine Hayward seal assembly kit. See "Shaft Seal Change Instructions" on the following page. Storage/Winterization ! WARNING - Separation Hazard. Do not purge the system with compressed air. Purging the system with compressed air can cause components to explode, with risk of severe injury or death to anyone nearby. Use only a low pressure (below 5 PSI), high volume blower when air purging the pump, filter, or piping. 21 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS