HealthRider Crosstrainer R790 X Bike Uk Manual - Page 7

9. Identify the Left Pedal (24), which is marked with an "L." Using an adjustable wrench, firmly tighten the Left Pedal counterclockwise into the Left Crank Arm (42). Tighten the Right Pedal (not shown) clockwise into the Right Crank Arm. Important: Tighten both Pedals as firmly as possible. After using the exercise cycle for one week, retighten the Pedals. For best performance, the Pedals must be kept tightened. Adjust the Left Pedal Strap (25) to the desired position, and press the end of the Pedal Strap onto the tab on the Left Pedal (24). Adjust the Right Pedal Strap (not shown) in the same way. 9 25 Tab 42 24 10. Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor. INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR If you purchase the optional chest pulse sensor (refer to page 19), follow the steps below to install the receiver and the jumper wire included with the chest pulse sensor. 1. Remove the indicated short screws and long screws from the back of the Console (16). Lift off the front of the Console. 1 16 Lift Here Short Screws Long Screws 2. Plug the jumper wire (A) into the indicated jack on the Console (16). Connect the other end of the jumper wire 2 to the wire on the receiver (B). Note: Any other wires included with the chest pulse sensor can be discarded. 16 Next, peel the paper off the adhesive pad on the back of the receiver (B). Orient the receiver as shown, and press it onto the Console (16) in the indicated location. Refer to step 1 above. Reattach the front of the Console (16) with the short screws and the long screws. Make sure that no wires are pinched. B Cylinder Jack A 7