HealthRider H55t Treadmill English Manual - Page 7
Assembly - assembly included
View all HealthRider H55t Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ASSEMBLY • To hire a service technician to assemble this product in your home, call 1-800-445-2480. • Assembly requires two persons. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps. • After shipping, there may be an oily substance on the exterior of the treadmill. This is normal. If there is an oily substance on the treadmill, wipe it off with a soft cloth and a mild, non-abrasive cleaner. • To identify small parts, see page 6. • Assembly requires the following tools: the included hex key one adjustable wrench one Phillips screwdriver scissors needlenose pliers To avoid damaging parts, do not use power tools. 1. Make sure that the power cord is unplugged. 1 Attach a Wheel (81) to the Base (80) with a 3/8" x 2 1/2" Bolt (2) and a 3/8" Nut (3). Do not overtighten the Nut; the Wheel must turn freely. Attach the other Wheel (not shown) to the other side of the Base (80) in the same way. 80 2 2. Remove the ties securing the Upright Wire (70) to the Base (80). Pull the Upright Wire and the 2 base ground wire (A) through the indicated hole in the Base (80). Attach the base ground wire (A) to the Base (80) with a #8 x 1/2" Ground Screw (1). Press a Base Cap (77) into each side of the Base (80). Make sure that the Grommet (67) is pressed into the square hole in the Base. 77 Hole 67 A 1 80 70 81 3 7