HealthRider Hotel Fitness Rb9700 Bike English Manual - Page 18
Maintenance And Troubleshooting
View all HealthRider Hotel Fitness Rb9700 Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the exercise cycle regularly. Replace any worn parts immediately. To clean the exercise cycle, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. HANDGRIP PULSE SENSOR TROUBLESHOOTING If the handgrip pulse sensor does not function properly, see step 5 on page 14. HOW TO ADJUST THE DRIVE BELT HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, first remove the screws from the left and right shields (not shown). Note: There are two different sizes of screws in the shields. Be sure to note the location of each screw. Then, carefully remove the shields. Next, see the drawing below and locate the Reed Switch (46). Loosen, but do not remove, the indicated M4 x 16mm Screw (77). Slide the Reed Switch slightly toward or away from a Magnet (30) on the Pulley (29). If the pedals slip while you are pedaling, even while the resistance is adjusted to the highest setting, the drive belt may need to be adjusted. To adjust the drive belt, first remove the screws from the left and right shields (not shown). Note: There are two different sizes of screws in the shields. Be sure to note the location of each screw. Then, carefully remove the shields. 46 24 29 30 77 47 38 B Then, retighten the M4 x 16mm Screw (77). Turn the Left Crank Arm (24) for a moment. Repeat until the console displays correct feedback. When the Reed Switch (46) is correctly adjusted, reattach the left and right shields. A Loosen, but do not remove, the three indicated screws (A). Insert the shaft of a screwdriver downward between the Idler Pulley (38) and the pulley on the eddy mechanism (B). Pull the top of the screwdriver toward the rear of the exercise cycle until the Drive Belt (47) is tight. Then, tighten the three screws and reattach the left and right shields. 18