HealthRider Hotel Fitness Rb9700 Bike English Manual - Page 8
Main Wire Harness 43 and to the Upper Pulse
View all HealthRider Hotel Fitness Rb9700 Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
6. Attach the Seat (9) to the Seat Carriage (41) with four M6 x 16mm Patch Screws (71) and four M6 6 Washers (88). Note: Only two Patch Screws and 9 two Washers are shown. 41 88 88 71 7. Have another person hold the Upright (2) near the Frame (1). See the inset drawing. Locate the wire tie in the Upright (2). Tie the lower end of the wire tie to the Main Wire Harness (43) and to the Upper Pulse Wire (42). Next, pull the upper end of the wire tie upward out of the top of the Upright. Then, untie and discard the wire tie. Tip: Do not allow the ends of the wires to fall into the Upright. Use a piece of tape or an elastic band to hold the wires in place until step 9. Tip: Avoid pinching the wires. Attach the Upright (2) to the Frame (1) with four M8 x 18mm Patch Screws (67) and four M8 Split Washers (93). Tip: Tighten the two Patch Screws in the front of the Upright and then tighten the other two Patch Screws. 8. Orient the Handlebar (7) as shown. Attach the Handlebar (7) to the Upright (2) with four M6 x 32mm Patch Screws (69). 7 42 43 67 93 Wire Tie 43 42 8 69 Avoid pinching the wires 2 93 67 93 93 67 1 69 7 2 8