HealthRider T600i Treadmill English Manual - Page 7

3. (Note: The parts shown in this step may be preassembled but may need to be adjusted.) With the help of a second person, raise the Frame (55) and hold it. Insert the Left Frame Guide (68) into the left side of the Frame. Remove the Lock Knob (67) from the Lock Pin (72). Make sure the Lock Pin Collar (70) and the Spring (69) are on the Lock Pin. Insert the Lock Pin into the Frame and the Left Frame Guide. Press the Latch Insert (5) onto the Frame, with the Lock Pin in the center hole. Tighten the Lock Knob onto the Lock Pin. Align the Lock Pin (72) with the hole in the Left Foam Grip (62) by sliding the Left Frame Guide (68) up or down. Make sure that the Lock Pin can be inserted fully into the hole. Hold the Left Frame Guide in place and tighten two 1/2" Screws (10) into the Latch Insert and the Left Frame Guide. Note: It may be necessary to pull the Lock Knob (67) to access and tighten the Screws. 4. Raise the treadmill to the storage position (see HOW TO FOLD THE TREADMILL FOR STORAGE on page 21). Have a second person hold the treadmill in the upright position. Position the U-base (20) against the base of the Uprights (65) as shown, with the Bumpers (98) under the U-base. Finger tighten two 2" Bolts (26) with Base Washers (34) into the base of the Uprights and the U-base. Then, attach the U-base with two 3" Bolts (23), two Base Washers (34), and two U-base Nuts (51). Tip the treadmill forward if necessary. Tighten the two 2" Bolts. 5. Make sure that all parts are properly tightened before you use the treadmill. Place a mat beneath the treadmill to protect the floor. For your benefit, familiarize yourself with the information on pages 23 and 24. 3 Hole 62 55 10 5 72 70 69 67 68 4 26 51 34 23 26 51 65 34 98 20 98 23 If you purchase the optional chest pulse sensor (see page 20), follow the steps below to install the receiver and the 1 short jumper wire included with the chest pulse sensor. 1. Make sure that the power cord is unplugged. Remove the indicated 3/4" Screws (40) from the Console Back (117), and remove the Console Back. 2. Connect one end of the short jumper wire (A) to the PULSE jack on the back of the Console (80). Connect the other end 2 of the short jumper wire to the wire on the receiver (B). Turn the receiver (B) so the cylinder is on the side shown, and hold the receiver against the back of the Console (80). Attach the receiver with the two small screws (C) included with the receiver. Make sure that no wires are pinched. See step 1 above. Reattach the Console Back (117) with the 3/4" Screws (40). Discard the other wires included with the receiver. 7 117 40 40 80 A C Cylinder B