HP 3PAR StoreServ 7450 4-node HP 3PAR StoreServ 7450 Storage Service Guide - Page 25
Replacing an SFP, Port details
View all HP 3PAR StoreServ 7450 4-node manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
5. Replace the SFP. See "Replacing an SFP" (page 25). 6. In the HP 3PAR Management Console, verify that the SFP is successfully replaced. The replaced port State is listed as Ready, the Mode is listed as Target, and the Connected Device Type is listed as Host. Figure 23 Port details Replacing an SFP 1. After identifying the SFP that requires replacement, disconnect the cable and lift the retaining clip to carefully slide the SFP out of the slot. 2. Remove the replacement SFP module from its protective packaging. 3. Carefully slide the replacement SFP into the adapter until fully seated, close the retaining clip to secure it in place, and reconnect the cable. 4. Place the failed SFP into the packaging for return to HP. 5. Reconnect the cable to the SFP module and verify that the link status LED is solid green. SFP Repair 25