HP 3PAR StoreServ 7450 4-node HP 3PAR StoreServ 7450 Storage Service Guide - Page 51
Adding a Storage System to the Service Processor, Connect the maintenance PC to the SP.
View all HP 3PAR StoreServ 7450 4-node manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Adding a Storage System to the Service Processor After successfully completing the Service Processor Setup Wizard, you must add the storage system to the configuration database of the SP. Adding the storage system permits the SP to communicate, service, and monitor the health of the system. To add the storage system to the SP: 1. Connect the maintenance PC to the SP. 2. In the SPMaint, type 3 and press Enter to select InServ Configuration Management. SPXXXXX 1 SP Main 3PAR Service Processor Menu Transfer media: ethernet Transfer status: No transfer yet Enter Control-C at any time to abort this process 1 ==> SP Control/Status 2 ==> Network Configuration 3 ==> InServ Configuration Management 4 ==> InServ Product Maintenance 5 ==> Local Notification Configuration 6 ==> Site Authentication Key Manipulation 7 ==> Interactive CLI for an InServ X Exit 3 3. Type 2 and press Enter to Add a new InServ. SP - InServ Configuration Manipulation Enter Control-C at any time to abort this process 1 ==> Display InServ information 2 ==> Add a new InServ 3 ==> Modify an InServ config parameters 4 ==> Remove an InServ X Return to the previous menu 2 4. Enter the IP address of the InServ and press Enter. SP - InServ Configuration Manipulation Enter Control-C at any time to abort this process Please enter the IP address of the InServ you wish to add -OR Enter QUIT to abort: 16:57:36 Reply='' Adding to firewall rules on interface eth0 Adding a Storage System to the Service Processor 51