HP 8/40 Converged Enhanced Ethernet Command Reference v6.4.0 (53-1001762-01, J - Page 143
Spanning Tree Protocol Commands, bridge-priority
View all HP 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 143 highlights
DRAFT: BROCADE CONFIDENTIAL Spanning Tree Protocol Commands Chapter 9 bridge-priority Synopsis Operands Defaults Command Modes Description Usage Guidelines Examples see Also Specifies the priority of the bridge. bridge-priority priority no bridge-priority priority Specifies the bridge priority. The range of valid values is 0-61440. The default priority is 32678. Protocol Spanning Tree mode Use this command to set the bridge priority for the common instance. Using a lower priority value indicates that the bridge might become root. Use the no bridge-priority command to return to the default settings. This command must be used to specify the priority of the bridge. The priority values can be set only in increments of 4096. To specify the bridge priority: switch#configure terminal switch(config)#protocol spanning-tree stp switch(conf-stp)#bridge-priority 8192 switch#configure terminal switch(config)#protocol spanning-tree rstp switch(conf-rstp)#bridge-priority 8192 switch#configure terminal switch(config)#protocol spanning-tree mstp switch(conf-mstp)#bridge-priority 8192 protocol spanning-tree Converged Enhanced Ethernet Command Reference 125 53-1001762-01