HP 8/40 Converged Enhanced Ethernet Command Reference v6.4.0 (53-1001762-01, J - Page 207
QoS Commands, cee
View all HP 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 207 highlights
DRAFT: BROCADE CONFIDENTIAL QoS Commands Chapter 12 cee Synopsis Operands Defaults Command Modes Description Usage Guidelines Examples See Also Applies a CEE Provisioning map on an interface. cee name no cee name Specifies the name of a previously created CEE map. Any existing CEE map must be removed before a new one can be applied. There is no CEE Provisioning applied on an interface. Interface configuration mode Use this command to apply a CEE map on an interface. Use the no cee command to remove the CEE Provisioning map. The CEE map applied on an interface should exist on the switch. To apply a CEE map on an interface: switch(conf-if-te-0/1)#cee demo Because the switch does not allow applying a CEE map that does not exist, the following error displays: switch(conf-if-te-0/1)#cee test % Error: Map does not exist cee-map Converged Enhanced Ethernet Command Reference 189 53-1001762-01