HP Cisco MDS 9120 HP StorageWorks C-Series iSCSI Configuration Guide (AA-RW7PE - Page 38

Creating an iSCSI host, Initial iSCSI Initiator EVA login, Create iSCSI Targets window

Get HP Cisco MDS 9120 - Fabric Switch PDF manuals and user guides View all HP Cisco MDS 9120 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 38 highlights

Figure 33 Create iSCSI Targets window 8. Click Create. 9. Select Admin > Save Configuration from the Device Manager menu bar. Repeat all of the above steps for the other C-Series switch. The iSCSI-enabled C-Series Fibre Channel switch setup is now complete. Creating an iSCSI host The host iSCSI Initiator must log in to the EVA storage controller before LUNs may be created. Initial iSCSI Initiator EVA login The iSCSI Initiator must log in to the storage controller so that the EVA storage controller can recognize the iSCSI Initiator's WWPN. By setting the controller port as a persistent target, the iSCSI Initiator will reconnect to the storage controller after a power cycle or reboot. 1. From the Microsoft iSCSI Initiator Properties window's Targets tab, click Refresh (Figure 34). The two virtual targets are listed (one for each C-Series switch). 38

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
Figure 33 Create iSCSI Targets window
8.
Click
Create
.
9.
Select
Admin > Save Con
fi
guration
from the Device Manager menu bar.
Repeat all of the above steps for the other C-Series switch.
The iSCSI-enabled C-Series Fibre Channel switch setup is now complete.
Creating an iSCSI host
The host iSCSI Initiator must log in to the EVA storage controller before LUNs may be created.
Initial iSCSI Initiator EVA login
The iSCSI Initiator must log in to the storage controller so that the EVA storage controller can recognize
the iSCSI Initiator’s WWPN. By setting the controller port as a persistent target, the iSCSI Initiator will
reconnect to the storage controller after a power cycle or reboot.
1.
From the Microsoft iSCSI Initiator Properties window’s Targets tab, click
Refresh
(
Figure 34
).
The two virtual targets are listed (one for each C-Series switch).
38