HP Cisco MDS 9120 HP StorageWorks C-Series iSCSI Configuration Guide (AA-RW7PE - Page 43
Cisco Gigabit Ethernet Switch Module for, HP p-Class BladeSystem Software Con, guration Guide
View all HP Cisco MDS 9120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Setup If you are not using DHCP, follow the setup instructions in the Cisco Gigabit Ethernet Switch Module for HP p-Class BladeSystem Software Configuration Guide, to assign the CGESM an IP address. Use a web browser to access the configuration management and operation features at http://10.10.10.168:80, where 80 is the default port number.. Use the web interface to disable the cross connection (XConnects) (ports 17 and 18) and to ensure all ports are in the same VLAN. Disabling the cross connection ports With XConnects between Interconnect A and Interconnect B, the multi-path solution may use loops established at the interconnect switching level. To avoid this, disable the XConnects. Each interconnect model has different XConnect ports. Some interconnects don't enable these ports by default. The following procedure assumes the use of CGESM. See the interconnect documentation for more information. 1. Log in to the first interconnect on the web switch web page at http://10.10.10.168:80. 2. Click the Configuration link in the left frame of the web page.(Figure 40). C-Series iSCSI 43