HP Cisco MDS 9134 Cisco MDS 9200 Series Hardware Installation Guide (OL-16188- - Page 45
Cisco MDS 9000 Family SSM, Status LED
View all HP Cisco MDS 9134 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Chapter 1 Product Overview Services Modules The Fibre Channel ports support hot-swappable Fibre Channel SFP transceivers, which can be short wavelength (SWL) for connectivity up to 1050 feet (500 m), or long wavelength (LWL) for connectivity up to 6.2 miles (10 km). All interfaces are autosensing 1-Gbps or 2-Gbps compatible. The ports also support coarse wavelength-division multiplexing (CWDM) SFP transceivers, which can be used for extended long wavelength (EWL) transmission or for CWDM. For more information about SFP transceivers, see the "Supported Transceivers" section on page 1-35. Figure 1-19 shows the SSM, which has the part number DS-X9032-SSM on the left side. Figure 1-19 Cisco MDS 9000 Family SSM 2 DS-X9032 17 Storage Services Module 4 5 20 21 8 9 24 25 1 3 12 13 28 29 16 32 4 120094 1 Status LED 2 1-Gbps/2-Gbps Fibre Channel port group 3 Link and speed LEDs 4 Asset tag Each module draws power from the 42 V supplied on the backplane with local DC/DC power converters and regulators. The control processor on the module provides power-on, offline, and online diagnostics. The control processor can be used to configure devices on the switching module and to gather statistical data from each port. The control processor monitors the DC/DC power source and temperature. The control processor signals the supervisor module and displays an alarm on its front panel when it detects a problem. The front panel on the services module provides basic status information, such as power-on, self-test running, self-test passed, alarm, and ready. The binary image for the services module is downloaded from the supervisor module. Prior to the image download, the control processor on the services module runs from the code stored on its local CompactFlash card. The image for an SSM can be specified using the SSI boot variable. For more information on how to specify the SSI boot variable, see the Cisco MDS 9000 Family CLI Configuration Guide. Note Software downloads are only necessary when a revision of the code is needed. The supervisor module can force a reset on the services module and controls whether or not power is applied to the switching module. If a single component or a set of components on the switching module fails, this failure does not disable another switching module if that is the only failure in the system. For the detection of most component failures, each switching module has a hardware watchdog timer that resets the card if it is not serviced periodically. OL-16188-01 Cisco MDS 9200 Series Hardware Installation Guide 1-27