HP Cisco MDS 9216A Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS - Page 794

nasb rediscover module Chapter 16 N Commands Send documentation comments to [email protected] nasb rediscover module To initiate the rediscovery of a target device, such as a disk or tape device, used for Network-Accelerated Serverless Backup (NASB) in a VSAN on a Storage Services Module (SSM) where the feature is enabled, use the nasb rediscover module command in EXEC mode. nasb rediscover module slot-number vsan vsan-id target-pwwn pwwn-id Syntax Description slot-number vsan vsan-id target-pwwn pwwn-id Specifies the slot number of the connected module. Specifies the current VSAN. The range is 1 to 4096. Specifies the pWWN for the target device. The form is hh:hh:hh:hh:hh:hh:hh:hh, where h is a hexadecimal number. Defaults None. Command Modes EXEC mode. Command History Release 2.1(2) Modification This command was introduced. Usage Guidelines None. Examples The following example shows how to initiate a rediscovery of a target device. switch# nasb rediscover module 2 vsan 9 target-pwwn 20:02:00:a0:b8:16:a1:5f nasb rediscovery initiated switch# Related Commands Command nasb module show nasb ssm enable feature Description Enables the NASB feature in configuration mode and allows you to configure the Storage Array Controller and multiple LUNs. Displays the NASB configuration on the SSM. Enables the NASB feature on the SSM. 16-4 Cisco MDS 9000 Family Command Reference OL-16217-01, Cisco MDS SAN-OS Release 3.x