HP Cisco MDS 9216A Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS - Page 817

Chapter 17 O Commands out-of-service xbar Send documentation comments to [email protected] out-of-service xbar To perform a graceful shutdown of the external crossbar switching module of a Cisco MDS 9513 Director, use the out-of-service xbar command in EXEC mode. out-of-service xbar slot no out-of-service xbar slot Syntax Description slot Specifies the external crossbar switching module slot number, either 1 or 2. Defaults None. Command Modes EXEC. Command History Release 3.0(1) Modification This command was introduced. Usage Guidelines Before removing a crossbar from an MDS 9500 Series Director, you must perform a graceful shutdown of the crossbar. The administrator must enter the EXEC mode out-of-service xbar command for a graceful shutdown of the external crossbar switching module in a Cisco MDS 9513 Director. out-of-service xbar slot The slot refers to the external crossbar switching module slot number. Note To reactivate the external crossbar switching module, you must remove and reinsert or replace the crossbar switching module. Caution Taking the crossbar out-of-service may cause supervisor switchover. For additional information about crossbar management, refer to the Cisco MDS 9000 Family CLI Configuration Guide. Examples The following example shows how to perform a graceful shutdown of the external crossbar switching module of a Cisco MDS 9513 Director. switch# out-of-service xbar 1 OL-16217-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family Command Reference 17-27