HP Cisco MDS 9216A Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS - Page 954

snmp-server Chapter 21 S Commands Send documentation comments to [email protected] snmp-server To configure the SNMP server information, switch location, and switch name, use the snmp-server command in configuration mode. To remove the system contact information, use the no form of the command. snmp-server {community string [group group-name | ro | rw] | contact [name] | location [location]} no snmp-server {community string [group group-name | ro | rw] | contact [name] | location [location]} Syntax Description community string group group-name ro rw contact name location location Specifies SNMP community string. Maximum length is 32 characters. Specifies group name to which the community belongs. Maximum length is 32 characters. Sets read-only access with this community string. Sets read-write access with this community string. Configures system contact. Specifies the name of the contact. Maximum length is 80 characters. Configures system location. Specifies system location. Maximum length is 80 characters. Defaults The default community access is read-only (ro). Command Modes Configuration mode Command History Release 1.0(3) 2.0(1b) Modification This command was introduced. Added group option. Usage Guidelines None. Examples The following example sets the contact information, switch location, and switch name. switch# config terminal switch(config)# snmp-server contact NewUser switch(config)# no snmp-server contact NewUser switch(config)# snmp-server location SanJose switch(config)# no snmp-server location SanJose 21-36 Cisco MDS 9000 Family Command Reference OL-16217-01, Cisco MDS SAN-OS Release 3.x