HP Cisco MDS 9216A HP StorageWorks C-Series iSCSI Configuration Guide (AA-RW7P - Page 11
C-Series IP Storage Services Modules (IPS-4, IPS-8), Multi-protocol Services Module (14/2)
View all HP Cisco MDS 9216A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
well as helping to provide data security. An alternative is to use IPSec to secure the connection, although there will be a performance impact. Client, Host, or iSCSI Initiator has the 'iSCSI Initiator' loaded on it to enable Target Resource Recognition & Attachment. Storage Target Resources (LUNs) appear as if they are local drives attached directly to the system. iSCSI Initiator iSCSI Initiator IP Network iSCSI Initiator C-Series IP Storage Services Modules, 14/2 Multi-protocol Services Module and MDS 9216i 1. Defines Client Access. 2. Defines Paths to Targets. 3. Converts Ethernet IP to FC Protocol and Vice Versa. 4. Provides Target Addressing. MDS Switch Fibre Channel Fabric MDS Switch SAN Storage FC has the LUNs (resources) configured without ANY special drivers, firmware, or protocols. HP Fibre Channel Storage Figure 1 Typical IP/FC network structure C-Series IP Storage Services Modules (IPS-4, IPS-8), Multi-protocol Services Module (14/2), and MDS 9216i switch The IP Storage Services Modules (IPS-4, IPS-8), Multi-protocol Services Module (14/2), and the MDS 9216i switch provide IP hosts access to Fibre Channel storage devices. The IP host sends SCSI commands encapsulated in iSCSI protocol data units (PDUs) to a C-Series IP port over a TCP/IP connection. At this point, the SCSI commands are transferred from an IP network into a Fibre Channel network and forwarded to the intended target. Figure 2 illustrates an IP Storage Services Modules (IPS-4, IPS-8), Multi-protocol Services Module (14/2), and MDS 9216i switch network. C-Series iSCSI 11