HP Cisco MDS 9216i Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS - Page 409

Chapter 6 Debug Commands debug ipconf Send documentation comments to [email protected] debug ipconf To enable IP configuration debugging, use the debug ipconf command in EXEC mode. To disable a debug command, use the no form of the command or use the no debug all command to turn off all debugging. debug ipconf {all | errors | events | info | pss} no debug ipconf {all | errors | events | info | pss} Syntax Description all errors events info pss Enables debugging for all IP configuration features. Enables debugging for IP configuration error conditions. Enables debugging for IP configuration tx/rx MTS events. Enables debugging for IP configuration information. Enables debugging for IP configuration PSS operations. Defaults Disabled. Command Modes EXEC mode. Command History Release 1.0(2) Modification This command was introduced. Usage Guidelines None. Examples The following example displays the system output when the debug ipconf all command is issued: switch# debug ipconf all switch# 2005 Mar 10 02:45:30 ipconf: Received MTS message 2005 Mar 10 02:45:30 ipconf: MTS message received opcode 862 source 0x00000601/27 2005 Mar 10 02:45:30 ipconf: Getting ip addresses on interface 5000000 2005 Mar 10 02:45:30 ipconf: Received MTS message 2005 Mar 10 02:45:30 ipconf: MTS message received opcode 862 source 0x00000601/27 2005 Mar 10 02:45:30 ipconf: Getting ip addresses on interface 5000000 2005 Mar 10 02:45:30 ipconf: Received MTS message 2005 Mar 10 02:45:30 ipconf: MTS message received opcode 862 source 0x00000601/27 2005 Mar 10 02:45:30 ipconf: Getting ip addresses on interface 5000000 Related Commands Command no debug all Description Disables all debugging. OL-16217-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family Command Reference 6-63