HP Cisco MDS 9222i Cisco MDS 9000 Family Fabric Manager Configuration Guide, R - Page 1130

Configuring SANTap Chapter 57 Configuring SANTap Send documentation comments to [email protected] Figure 57-5 Create SANTap DVT Dialog Box Step 4 Step 5 Step 6 Step 7 Step 8 Step 9 Step 10 Step 11 Step 12 Select the switch on which the SANTap DVT will be configured. Select the VSAN ID in which you want to create the SANTap DVT. Select the port WWN of the real target for which this corresponding DVT is being created. The DVT has the same port WWN as the target. Select the target VSAN ID for the VSAN of the real target for which this DVT is being created. Select the interface. This is the port on the module where the DVT will be created. Assign a name to this SANTap DVT. Check the LunSizeHandling option if you want to use the real target LUN size for the virtual LUN or the maximum LUN size supported (2TB). Select the IOTimeout value for the DVT. The default value is 10 seconds. Click Create to create this SANTap DVT. Deleting a SANTap DVT To delete a SANTap DVT using Fabric Manager, follow these steps: Step 1 Step 2 Step 3 Step 4 Expand Switches > End Devices and then select SSM Features from the Physical Attributes pane. You see the FCWA tab in the Information pane. Click the SANTap DVT tab. You see the SANTap configuration in the Information pane. Select the SANTap DVT you want to delete. Click Delete Row. You see the Fabric Manager Confirmation dialog box. 57-6 Cisco MDS 9000 Family CLI Configuration Guide OL-16184-01, Cisco MDS SAN-OS Release 3.x