HP Cisco MDS 9222i Cisco MDS 9000 Family Fabric Manager Configuration Guide, R - Page 1177

Chapter 62 Monitoring Network Traffic Using SPAN Configuring SPAN Send documentation comments to [email protected] Step 10 Click Close in each of the three open dialog boxes. Deleting SPAN Sessions To delete a SPAN session using Device Manager, follow these steps: Step 1 Step 2 Step 3 Step 4 Step 5 Choose Interface > SPAN. You see the SPAN dialog box. Click the Sessions tab. Click the SPAN session you want to delete. Click Delete. The SPAN session is deleted. Close the dialog box. SPAN Conversion Behavior SPAN features (configured in any prior release) are converted as follows: • If source interfaces and source VSANs are configured in a given session, then all the source VSANs are removed from that session. For example, before Cisco MDS SAN-OS Release 1.0(4): Session 1 (active) Destination is fc1/9 No session filters configured Ingress (rx) sources are vsans 10-11 fc1/3, Egress (tx) sources are fc1/3, Once upgraded to Cisco MDS SAN-OS Release 1.1(1): Session 1 (active) Destination is fc1/9 No session filters configured Ingress (rx) sources are fc1/3, Egress (tx) sources are fc1/3, Session 1 had both source interfaces and source VSANs before the upgrade. After the upgrade, the source VSANs were removed (rule 1). • If interface level VSAN filters are configured in source interfaces, then the source interfaces are also removed from the session. If this interface is configured in both directions, it is removed from both directions. For example, before Cisco MDS SAN-OS Release 1.0(4): OL-16184-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family CLI Configuration Guide 62-9