HP Cisco MDS 9222i Cisco MDS 9000 Family Fabric Manager Configuration Guide, R - Page 368

Default Settings Chapter 19 Managing Modules Send documentation comments to [email protected] Table 19-8 LEDs for the Cisco MDS 9500 Series Supervisor Modules LED Status Description Status Green All diagnostics pass. The module is operational (normal initialization sequence). Orange One of the following applies: The module is booting or running diagnostics (normal initialization sequence). An over temperature condition has occurred (a minor threshold has been exceeded during environmental monitoring). Red One of the following applies: The diagnostic test failed. The module is not operational because a fault occurred during the initialization sequence. System1 Green An over temperature condition occurred (a major threshold was exceeded during environmental monitoring). All chassis environmental monitors are reporting OK. Orange One of the following applies: The power supply has failed or the power supply fan has failed. Incompatible power supplies are installed. The redundant clock has failed. Red The temperature of the supervisor module major threshold has been exceeded. Active Green The supervisor module is operational and active. Pwr Mgmt1 Orange The supervisor module is in standby mode. Green Sufficient power is available for all modules. Orange Sufficient power is not available for all modules. MGMT 10/100 Green Ethernet Link Off LED Link is up. No link. MGMT 10/100 Green Ethernet Off Activity LED Traffic is flowing through port. No link or no traffic. CompactFlash Green The external CompactFlash card is being accessed. Off No activity. 1. The System and Pwr Mgmt LEDs on a redundant supervisor module are synchronized to the active supervisor module. Default Settings Table 19-9 lists the default settings for the supervisor module. 19-12 Cisco MDS 9000 Family CLI Configuration Guide OL-16184-01, Cisco MDS SAN-OS Release 3.x