HP Cisco Nexus 5000 Cisco Nexus 5000 Series Release Notes Release 4.1(3)N1(1) - Page 13

Caveats Send documentation comments to [email protected] • CSCsu01188 Symptom: No traps are sent when SFPs for Gigabit Ethernet and 10-Gigabit Ethernet are removed or inserted. Workaround: None. • CSCsv56881 Symptom: Each Switched Virtual Interface (SVI) for inband management must be configured with a different IP address. IPv6 has an error check feature. When an administrator enters a duplicate IPv6 address across two SVIs, the software fails the command due to the duplicate address. A similar error check should exist for IPv4 address configuration on SVIs. Workaround: Do not configure duplicated IPv4 or IPv6 addresses. • CSCsv02866 Symptom: The command show interface ethernet transceiver details may show invalid calibration for DOM-supported 1 G SFP. Workaround: None. • CSCsv00989 Symptom: The show interface ethernet transceiver details command may show all zero values for a DOM-capable 1 G SFP. Workaround: None. • CSCsu48008 Symptom: When a Virtual Fibre Channel (VFC) interface is down, the fcIfOperStatusCause MIB object does not report the correct reason. Workaround: Get the OperStatus from the CLI using the show interface vfc x command. • CSCsu77946 Symptom: Within a configuration session, when you enable statistics on the PACL add more than 252 ACES to the ACL, and apply it to an interface, an error message is generated as the statistics counter is exhausted. Even if you try to remove the statistics keyword, it does not get removed. The result is that the ACL cannot be applied to the interface. This problem occurs only with a configuration session, and only after a configuration failure. Workaround: Reduce the size of the ACL (fewer than 252 ACES) and re-apply the ACL to an interface. The statistics keyword will still remain and consume hardware resources. • CSCsv19979 Symptom: Any FC port set to SD mode does not come up until the speed is configured manually. The port goes into the error disabled state and the only way to bring it online as SD is to manually set the speed 2 G or 4 G. Workaround: Configure the speed manually to 2 G or 4 G. • CSCsr20499 Symptom: When you restore a configuration to running-config from a configuration file, ACL manager may leak memory. The size of the leak is related to the size of ACL configurations and the number of times the restoration occurs. The switch may reboot if the ACL configuration is very large and the restoration occurs too many times. Workaround: None. OL-16601-01 Cisco Nexus 5000 Series and Cisco Nexus 2000 Series Release Notes, Release 4.1(3)N1(1) 13