HP Cisco Nexus 5000 Cisco Nexus 5000 Series Release Notes Release 4.1(3)N1(1) - Page 17

Caveats Send documentation comments to [email protected] Workaround: Use the Ethernet SPAN destination port to SPAN Fibre Channel traffic. FCoE packet going out of the Ethernet SPAN destination port will contain VSAN information in the Ethernet VLAN tag. • CSCsv93278 Symptom:The logging server vrf command works only with the management vrf. There is no functional impact if the syslog is to be sent over management vrf. Workaround: None. • CSCsv93922 Symptom: If the modulo(%) operator is used in a Cisco Nexus 2000 Series Fabric Extender description the show fex command brings up the following error message ERROR: bad format: non escaped % not followed by 's'. Workaround: Remove the modulo(%) operator from the Cisco Nexus 2000 Series Fabric Extender description • CSCsv95478 Symptom:The Cisco Nexus 2000 Series Fabric Extender pinning redistribute command does not wait for user prompt with a yes or no operation. Workaround: None. • CSCsv15775 Symptom: When priority tagged frames are received on Cisco Nexus 2000 Series Fabric Extender ports, they are dropped and not forward on the nativeor default VLAN of the port. The MAC addresses are not learned. Workaround: None. Resolved Caveats-Cisco NX-OS Release 4.1(3)N1(1) This section lists the resolved caveats for this release. • CSCsx39376 Symptom: If user is created w/ AES privacy password and login without the privacy password, user won't be able to delete any normal user. System will just times out Workaround: If user is created w/ A • CSCsw39639 Symptom: When a rule that refers to a specific interface name (e.g. Ethernet 1/1) is entered in the role definition CLI, the command could hang. Ctrl-C can be issued to get back the CLI prompt. Workaround: Do not configure rules that refer to specific interfaces in the role definition CLI. • CSCsv13371 Symptom: Interface reset and clearing counters do not get updated. Workaround: None • CSCsv65911 Symptom: The RMON alarm configuration is not shown when issuing show running-config. This is only a show issue, the configuration gets saved correctly with copy running-config startup-config and is restored correctly after a reload. Workaround: None. OL-16601-01 Cisco Nexus 5000 Series and Cisco Nexus 2000 Series Release Notes, Release 4.1(3)N1(1) 17