HP Cluster Platform Introduction v2010 HP Cluster Platform Server and Workstat - Page 233
Removing and Installing PCI or PCI-X Cards, Installing PCI Express Cards
View all HP Cluster Platform Introduction v2010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 233 highlights
5. If required, plug in the power supply cable (callout 4). 6. Close the PCI levers (callout 5). If the PCI levers do not close, be sure all of the cards are properly seated. Figure 5-23 Installing PCI Express Cards 1 1 5 5 3 2 4 5.3.9.3 Removing and Installing PCI or PCI-X Cards Note: The following illustration shows a PCI card being removed from a PCI slot. A PCI-X card is removed from a PCI-X slot. To remove a PCI or PCI-X card, refer to the callouts in Figure 5-24 and follow these steps: 1. Disconnect power from the system, remove the access panel and remove the PCI card support, if installed. 2. Lift the PCI levers (callout 1) by first pressing down and then up. 3. Lift the PCI card (callout 2) out of the chassis. Store the card in an antistatic bag. 4. Install a PCI slot cover and close the PCI levers. If the PCI levers do not close, be sure all cards are properly seated and then try again. Figure 5-24 Removing PCI, or PCI-X Cards 1 1 2 5.3 HP xw9300 Workstation Overview 233