HP Contura 400 Compaq Contura 400 Family of Personal Computers Maintenance and - Page 153
Removing the CSTN 9.5 inch Panel, Shield, Display Cable, and the Display, Ground Cable
View all HP Contura 400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 153 highlights
Removing the CSTN (9.5 inch) Panel, Shield, Display Cable, and the Display Ground Cable To remove the liquid crystal display CSTN (9.5 inch) panel, the shield, the display cable and the display ground cable, follow these steps: 1. Disconnect all power from the computer and remove the AC Adapter and battery pack (Section 3.2). 2. Open the computer. CAUTION The computer becomes top heavy when the keyboard assembly is removed and the display is opened. To prevent damage to the display and the computer, ensure that the display assembly is opened at a 90-degree angle. 3. Remove the keyboard assembly (Section 3.7). CAUTION The ZIF connector and its attached cable can be damaged easily. Handle only the connector slide when disconnecting the ZIF connector. Never pull or twist the cable itself while it is seated in the ZIF connector. 4. Remove the display cable from the system board by pulling up both ends of the ZIF connector slide simultaneously [1], carefully opening the slide [2] (Figure 3-101). 5. Lift the display cable out of the connector slide [3], being careful not to pull or twist the cable (Figure 3-101).