HP Dc5700 Network & Internet Communications Guide - Page 9

NOTE NICs featuring Alerting Capabilities comply with Alert Standard Format (ASF) specification 2.0 and support Remote Management and Control Protocol (RMCP) based alerts. ASF 1.0 implementations will not support RMCP due to lack of security in the ASF 1.0 specification. NIC-Based Alerts are enabled and configured by installing the ASF 2.0 agents for the NIC you are using. These are available at http://www.hp.com. ASF alerts can also be enabled and configured using the Common Information Model (CIM). Wake-On-LAN Support (WOL) To enable or disable Wake-On-LAN from a power off state: 1. Run the Computer Setup utility by pressing F10 at POST. 2. In the Advanced menu, select Device Options > S5 Wake on LAN. 3. Select Disable to prevent WOL from occurring while the computer is in a power off state or select Enable to allow WOL to occur from a power off state. NOTE The default state for S5 Wake on LAN is Enable. To enable or disable Wake-On-LAN from a low power state: Windows XP 1. Select Start > Control Panel. 2. Double-click Network Connections. 3. Double-click Local Area Connection. 4. Click Properties. 5. Click Configure. 6. Click the Power Management tab, then select or clear the check box to Allow this device to bring the computer out of standby. Windows 2000 1. Select Start > Settings > Control Panel. 2. Double-click Network and Dial-up Connections. 3. Right-click Local Area Connection. 4. Click Properties. 5. Click Configure. 6. Click the Power Management tab, then select or clear the check box to Allow this device to bring the computer out of standby. NOTE For more information on Wake-On-LAN, refer to the Remote Management Administrators Guide. The Remote Management Administrators Guide is included with the Remote Management Setup Utilities and is available on the Support Software CD or at http://www.hp.com. ENWW Wake-On-LAN Support (WOL) 3