HP DesignJet 3000 HP DesignJet 2000/2500 - User's Guide - Page 288
The printer has detected that the amount of ink in the ink systems indicated by one
View all HP DesignJet 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 288 highlights
Front-Panel Messages Message Explanations and Actions Message Explanation and Action Open window to access printheads You are doing an ink system replacement. Open the window to access the printheads. OUT OF INK ssst → The printer has detected that the amount of ink in the ink systems indicated by one or more flashing squares, is below acceptable limits for satisfactory printing. Press ↓ to check the indicated ink systems. See 11-38, Checking Ink Systems. You will be prompted to change the kit or to ignore the error and continue printing. If there is still a large amount of ink remaining in the ink cartridges, see the message Printhead failure on page 12-12. Out of memory Data was lost The current file is too large for the printer's memory; the printer has run out of disk space for processing the file. To print files of this size, you may need to install more memory to your printer. Press ENTER when The printer is waiting for you to confirm an action or selection. done When you have taken the appropriate action press the Enter key. Printhead alignment cancelled→ The printhead alignment procedure has failed, or the printer has detected a fault that stops the procedure from completing. Subsequent messages will explain the error further: s "Replacement of lens cover recommended"-You should check the section on replacing lens covers on page 10-3, Lens Maintenance. s "Media too small for calibration"-The roll that is loaded is not wide enough for the calibration to be done. It must be at least A3 size. You should load appropriate media and repeat the procedure again, using Image Quality / Printhead Service / Align Now. If you use sheet media that is too small, the printer will reject the media and prompt you to load new media. Press ↓ to continue. You may continue printing, but you may not get your usual image print quality. To fix problems with the ink system, see 11-38, Checking Ink Systems. Printhead alignment error ssts→ or Printhead alignment error → The printhead alignment procedure has failed, or the printer has detected a fault that stops the procedure from completing. The squares that are flashing indicate the ink systems that have failed. If the message contains no squares, the procedure has failed because of a problem that is not related to specific printheads, for example, a problem with the media. Press ↓ to continue. The message "Check ink system→ / Ignore→" should be displayed. If you press ↓ again to continue, you may still be able to print again, but image print quality may be affected. To fix the problem, select ↑ to check the ink system; see 11-35, Printhead Alignment Errors. 12-10