HP DesignJet 3000 HP DesignJet 2000/2500 - User's Guide - Page 293
Sheet / Roll?, System Error
View all HP DesignJet 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 293 highlights
Front-Panel Messages Message Explanations and Actions Message Sheet misaligned Reload sheet Sheet required for calibration Sheet / Roll? Reload media STATUS messages Switch power off Switch power off Check paper path Switch power off Check printhead path System Error 060000 System error XXXXXX Explanation and Action Sheet media is skewed. Remove it and reload it so that the left and right edges being loaded into the printer are square. The leading edge must also be straight. You have started an accuracy calibration check but media is not present. Load media. Either: Sheet mode was chosen while loading roll media. Reload media. Or: a sheet more than 51 inches (130 cm) long was loaded. Trim the sheet and reload. See pages 12-17 through 12-21. You have selected the transport mode shut-down sequence. The printer is waiting for you to turn the power switch, on the rear of the printer, to off. Switch off the printer. The printer may be jammed with media. Turn off the printer. Check the media path and clear it if necessary. Then turn on the printer. The printhead carriage cannot move. The printer may be jammed with media. Turn off the printer. Check the media path and clear it if necessary. Then turn on the printer. The ambient light level in the area of your printer is too bright and is causing the optical sensor in your printer to malfunction. Reduce the ambient light level or move the printer to a location where the light level is lower. An internal error has occurred and a system error number is displayed. Press Enter; this may clear the error and allow you to continue. If you cannot continue, turn off the printer, and then turn it on again. If you still see the system error message, record the system error number and call HP to have the printer serviced. 12-15