HP Designjet 2000/3000cp HP DesignJet 2000/2500 - User's Guide - Page 253
Checking Ink Systems, Monitoring the Ink Level, Printhead Alignment Errors, Printhead Checks
View all HP Designjet 2000/3000cp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 253 highlights
Out of ink Troubleshooting Solving Ink System Problems One or more of the four ink systems are out of ink. If the last print showed image print quality degradation, replace the ink systems affected. n See 11-38, Checking Ink Systems. n Check the ink levels (see 4-9, Monitoring the Ink Level). If there is still a large amount of ink remaining in the ink cartridges, see the message "Printhead failure". Printhead alignment cancelled This message occurs when the alignment routine is cancelled because of a dirty lens cover or a problem with the media. n See 11-35, Printhead Alignment Errors. Printhead alignment This message occurs when the printhead alignment procedure has failed, or the error printer detects a fault that stops the process from completing. Alignment is the first procedure that prints with the printheads after installation, so some printing problems may be reported as a Printhead Alignment Error. Most alignment errors are due to a fault with the printheads, or problems with the media. n See 11-35, Printhead Alignment Errors. Printhead check cancelled Printhead check error This message occurs when a printhead check is cancelled because of a dirty lens cover or a problem with the media. n See Printhead Checks on page 11-37. This message occurs when the printhead check procedure has failed, or the printer detects a fault that stops the process from completing. Most printhead check errors are due to a fault with the printheads, or problems with the media. n See Printhead Checks on page 11-37. Printhead contact There is an electrical problem with one or more of the printheads. error n See the message "Printhead contact error". Printhead failure The ink systems have failed and should be replaced. n See the message "Printhead failure". Printhead removed One or more of the printheads are not detected by the printer. Printing has been disabled. n See 11-38, Checking the Printheads. Verify ink system At power-on, the printer has detected an error in one or more of the ink systems. n See 11-38, Checking Ink Systems. 11-33