HP Designjet 2000/3000cp HP DesignJet 2000/2500 - User's Guide - Page 285
Replace Ink System, Enter, print side down
View all HP Designjet 2000/3000cp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 285 highlights
Message INK SYSTEM ERROR xxxxxx Install complete Lift lever after aligning Lift lever to continue Load arrow edge print side down Load cancelled Remove media Load error Remove media Load media for calibration Load media to align printheads Front-Panel Messages Message Explanations and Actions Explanation and Action The printer has detected an error in the ink system, as shown in earlier messages. Printing will be disabled until the error has been corrected. If more than one error is pending, the one with the highest number, corresponding to the most severe error, will be displayed. Possible error codes (xxxxxx) are: • 58.... See the message "Incorrect ink system" • 65.... or 66.... See the message "Printhead failure" • 67.... See the message "Printhead contact error" • 72.... See the message "Ink cartridge removed" • 73.... See the message "Head cleaner removed" • 74.... See the message "Printhead removed" • 88.... See the message "Mixed ink system". Press the Replace Ink System key to replace the erroneous ink systems in order to print with your printer again. See 11-38, Checking Ink Systems. Press the Enter key to access the main front panel menus. Ink system replacement has been completed successfully. Resume normal operations. You have lowered the media lever to align the media with the entry platen. Lift the lever at the right edge of the paper path on the printer when you've finished aligning the roll media as instructed. The media lever was lowered while the processor was busy. Lift the lever at the right edge of the paper path on the printer. Remove the accuracy calibration print, turn it so that the edge with the arrows printed on it is print-side down, then load that edge into the printer. The Cancel key was pressed while media loading was in progress. Remove media. Media was inserted with the media lever raised. Lower the lever and reload the media. Load media to proceed with calibration. Load media to proceed with printhead alignment. 12-7